Products

Replacement Canopy Top by HardDrive.

Canopy with Top.

Canopy by HardDrive.

Replacement Canopy Top by HardDrive.

• Curve bill with structured crown • Snap back • Twill main fabric • Front Astars with camo fill embroidery, with side flat embroidery logo • Internal and back labeling

FULL SPECS A blend of polyester, cotton and rayon jersey for breathability, moisture-wicking comfort & soft hand feel Ribbed collar and taped shoulder seams for comfort and fit retention Crewneck style Custom KLIM graphic on chest and back Screen-print inks...

Cap Assembly Replacement for Utility Container.

Replacement cap connectors.

Replacement Cap for Motorsport Container.

4 pack Cap gaskets only For FCR Economy Carb Rebuild Kit.

Pours 5 gallons in thirty eight seconds Fluids stop flowing after reaching the end of the spout automatically Just pull up and the valve shuts off fluid flow No vent to open and close or to leak when pouring Stops...

Classic Printed TeeFront script Alpinestars word graphic. Soft hand printInternal neck print, external labeling30/1, 90% Combed Ring spun Cotton / 10% Polyester', 150 g/m2 (Grey Heather)30/1, 100% Combed Ring spun Cotton, 150 g/m2

Masculine, square-shaped frame design with a low based curve to comfortably fit most faces Luxurious, soft-touch rubberized frame finish Smoke tint anti-fog polycarbonate lenses are shatter-resistant Provide 100% UVA and UVB protection Microfiber storage pouch included.

Sold per set of 10.

Meets or exceeds OEM Specifications For Keihin 40mm CV Carbs.

Each set contains 1 diaphragm with rod attached, 1 rubber boot for rod, spring and O-ring as required Sold as a set, 3 or 4 piece as noted.

Carb Rebuild Kit.

Includes all the necessary needles, O-rings, etc. for a complete rebuild.

Kits are intended for closed course racing only.NBR rubber material is used on all O-rings and rubber gaskets..NBR has excellent resistance to the ethanol used in todays fuels.Components included in the kits are based off of US models and discretion...

Carb Repair Kit for Mikuni Float Style Carburetors.

Increases the distance. between the carburetor and the engine Adds approximately 3 horsepower by changing the air/fuel flow dynamics Made from hard-anodized billet aluminum Includes mounting hardware and instructions Made in the USA.

Carburetor/intake support bracket for `66-84 Big Twin and Shovelhead motors Contrast cut 6061-T6 Aluminum Works with Old-Stf rocker box oil lines, passing through the middle. Supports your fuel line, plug wires etc. Measures 5. 3in. eyelet to eyelet, 1in. wide...